Adapter flange twix airhead & oilhead

An adapter flange is needed between the output flange of the airhead gearbox and the drive shaft of the oilhead swing arm.

The adapter has a round spigot that is press fit into the female spline of the uni-joint on the R1100 drive shaft. Then the adapter will be welded to the uni-joint. The adapter is turned and milled from a piece of 75mm K1045 round bar.

flange_finished

flange_onBike

 

flange_ready

ready for welding

flange_weld1

flange_weld2

4 replies
    • adrian
      adrian says:

      Hi Andre,
      I’ve had a few requests now so time to pull my finger out!
      I’ll try to publish something within the next week or so…
      Cheers
      Adrian

      Reply

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply to Mike Lydon Cancel reply

Your email address will not be published.

five × three =