Adapter flange twix airhead & oilhead
An adapter flange is needed between the output flange of the airhead gearbox and the drive shaft of the oilhead swing arm.
The adapter has a round spigot that is press fit into the female spline of the uni-joint on the R1100 drive shaft. Then the adapter will be welded to the uni-joint. The adapter is turned and milled from a piece of 75mm K1045 round bar.
ready for welding
Might you be sharing drawings of this adapter with others?
I’ll get a sketch together and email to you.
This is a long shot, but any chance of also getting sketch of this adapter? It would really be appreciated.
Hi Andre,
I’ve had a few requests now so time to pull my finger out!
I’ll try to publish something within the next week or so…
Cheers
Adrian